Speaking of wet curtain air coolers, this is also a hot-selling environmentally friendly cooling equipment. The weather is getting hotter and hotter, and the high temperature in many places across the country is expected to reach 10 degrees. Enterprise workshops and farms must check whether the equipment can be more efficient. , safe and economical cooling, we can check from the following three points. Generally, dust will accumulate on the filter screen of the wet curtain cooler after the system has been running for a period of time, increasing air resistance or indoor unit leakage, thus causing the air volume to decrease or become blocked. If it dies, it will obviously affect the efficiency of the wet curtain air cooler, so it needs to be cleaned regularly.
Summer has just arrived. Check to see if after a period of time, the wires and components of the equipment will heat up and cause the joints to loosen and fall off, resulting in poor contact and phase loss. If there is any, try to drain it to avoid any influence. Summer use.
Check frequently. Failure of protection devices such as water flow switches, high and low pressure switches, and safety valves may cause accidents. If found, they should be replaced in time.
Warm reminder: When servicing the wet curtain air cooler, be sure to turn off the power first. It is best to wait for a while after cutting off the power, because long-term use will generate static electricity, and the static electricity will not disappear immediately after the power is turned off, so make sure Carry out maintenance after it is safe.
Zhenglan Environmental Protection has accumulated experience in ventilation and cooling in recent years and summarized countless ventilation and cooling cases. The conclusion is that the most effective way to cool down a general factory is to use negative pressure air combined with wet curtains, or the use of air coolers has the most significant effect. And the investment is small and the cost input is low.
The wet curtain air cooler has a large air volume, is corrosion-resistant, acid-alkali-resistant, and has a long service life. It can discharge all dust, odor, stuffy heat, greasy, and other bad factors from the workshop. Use air convection to inject fresh outside air into the workshop to make the working environment comfortable and healthy. For workshops with high temperatures, the ventilation effect is better when equipped with wet curtains or air coolers. The air cooler can quickly discharge the turbid air in the workshop, and the air cooler can quickly inject cold air to achieve the best effect of ventilation and cooling.
If the factory is well ventilated, workers will be more efficient. If you want good ventilation, water cooling fans are indispensable.